MAC/MTT-OPS-1
26 FEB 2019
Appendix
MAC/MTT Operators Checklist
A-7
MAC/MTT-OPS(CL)-1
26 FEB 2019
7. Cab Control SYSTEM/POWER Switch – OFF
GPS Auto Mode
When the chassis ignition switch is turned on, the
GPS module will attempt to make a satellite
connection. During this time, the AUTO light on the
cab control box will blink until a satellite connection
is established. If the AUTO light still blinks when the
cab control POWER switch is turned ON, then the
satellite connection has not yet been established.
Connection may take up to 10 minutes.
1. Cab Control POWER Switch – ON
2. RATE and SPEED Dials - SET
3. AUTO – ON AS REQUIRED
4. Desired Spray Head Switches – ON
N-6
To Next Page
Loading...