EasyManua.ls Logo

Mega MULTITRUCK 400 – 600 - Page 41

Default Icon
46 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5-Service management
How much distance has been covered since the last service. Calculated with the
odometer.
First service = 1000Km or 1 year
Normal service 5000Km or 1 year
When the ignition is on, you can see the distance to the next service during 5 second, it is
displayed instead of the odometer with a little symbol (key) .Afterward the odometer came back
and the key symbol disappear.
If the distance to the next service is less than 200 Km, the distance displayed will blink for 5
second and after the key symbol will stay on.
If the time to the next service is less than 20 days, the message “1 year” displayed will blink for 5
second and after the key symbol will stay on.
When the time to the next service is completely past, the message “1 year” is displayed for 5
second and the key symbol will stay on.
To reset the service management:
- Put the ignition on
- Push on the two buttons for 6 second until 10 second after the ignition is
on.
6-Turning lights and hazard lights
Turning lights management and right and left display indicator management. .
In good order: 100 blinking per minute.
With a broken bulb: 200 blinking per minute.
Turning lights are only available when the ignition is on, hazard light are always available.
The buzzer works with the hazard and turning lights.
The buzzer will also advise you if the lamps are on when you want to leave the vehicle:
- The ignition must be off
- The lamp must be on
- The door must be open
7-Indicator lights and hazard lights
Indicator lights managed by the display:
Low beam lamp
Hi beam lamp
Charging system defect
Low oil pressure
High cooling system temperature
Brake pad wear
Handbrake and low brake fluid level