Megger MIT1020/2 - Advanced Controls and Connectivity; Mode, Fn, and Timer Button Operations

Figure 3 - The result of a dielectric discharge test (DD)
Test settings: T1 and T2 times set in order to measure the DAR
Test condition: test runs for longer than 10 minutes as this is required for
a PI reading.
Figure 2 - The result of a polarity index test (PI)
Test settings: T1 and T2 times set in order to measure the DAR
Test conditions: timer defaults to 10 minutes, as this is required for a PI
reading
9
Press Ω/I
Press Ω/I
Press Ω/I
Press Ω/I
Press Ω/I
Press Ω/I