Need help?Do you have a question about the Megger MIT2500 and is the answer not in the manual?
General| Voltage Measurement | 0 to 600 V AC/DC |
|---|---|
| Safety Rating | CAT IV 600 V |
| Test Current | 1 mA |
| Display | LCD |
| Battery Type | 6 x AA batteries |
| Continuity Range | 0.01 Ω to 1000 Ω |
| Battery Life | Approx. 8 hours |
| Operating Temperature | -10°C to +50°C |
| Storage Temperature | -20°C to +60°C |
| Safety Standards | IEC 61010-1 |
Crucial safety warnings and precautions that must be read and understood before using the instrument.
Illustrates the different terminal connections available on the instrument.
Details the connections for 2-terminal and 2-terminal plus Guard configurations.
Explains how to connect and use the 3-terminal configuration for measurements.
Describes how to operate the instrument using the 3-terminal setup and select measurement pairs.
Procedures for measuring AC and DC voltage using 2-terminal connections.
Procedures for measuring AC and DC voltage using 3-terminal connections.
Safety precautions and the basic procedure for performing insulation resistance tests.
Detailed steps for conducting insulation resistance tests using 2-terminal connections.
Procedures for performing insulation tests with variable voltage settings.
Instructions for performing Polarisation Index (PI) and Dielectric Absorption Ratio (DAR) tests.
Step-by-step guide for conducting the DAR measurement.
Steps for performing timed insulation resistance tests.
Performing insulation tests using the 3-terminal configuration.
Procedure for performing continuity tests using 2-terminal connections.
Steps for measuring capacitance using 2-terminal connections.
Guide to navigating and configuring the instrument's setup options.
To Next Page
