Need help?Do you have a question about the Megger MPRT 8415 and is the answer not in the manual?
General| Channels | 15 |
|---|---|
| Maximum Voltage | 300 V AC/DC |
| Display | LCD |
| Power Supply | 100 to 240 V AC, 50/60 Hz |
| Safety Standards | IEC 61010-1 |
| Test Current | Not applicable |
| Battery Type | Not applicable |
Critical warning regarding hazardous voltages and general safety practices.
Detailed safety instructions for operating the MPRT test system.
Overview and description of the MPRT unit's controls and indicators.
Detailed description of the buttons and indicators on the MPRT front panel.
Explanation of the ports and connectors located on the MPRT rear panel.
Details on the MPRT's primary operator interface, including display and control knob.
Configuration and specifications for the Voltage/Current Generator modules.
Configuration and function of binary inputs used for timer operations.
Details on using the battery simulator for DC logic voltage supply.
Initial steps for setting up the MPRT unit, including unpacking and checks.
Explanation of the touch panel display, keypad entry, and control knob functions.
Overview of default configurable settings like language, color, and system parameters.
Description of the various ports available for unit communication and data transfer.
Basic procedures for operating the MPRT via its touch screen and control knob.
Method for connecting multiple current channels in parallel for increased capacity.
Procedure for connecting current channels in series to double compliance voltage.
Steps for conducting harmonic restraint tests using current sources.
Procedure for dynamically testing Over/Under Voltage relays with timed voltage changes.
Configuring basic timer parameters for relay testing requirements.
Overview of the MPRT's graphical user interface for relay testing.
Accessing test modes, system configuration, and file management from the main menu.
Selecting from a variety of pre-defined relay-specific test routines.
Configuring settings for impedance or distance relay tests.
Establishing pre-fault conditions and test parameters for reach tests.
Configuring parameters for performing impedance relay timing tests.
Configuring settings for overcurrent relay tests, including curve types.
Entering or verifying values required for differential relay tests.
Configuring settings for voltage relay tests, including inverse time characteristics.
Configuring settings for synchronous relay tests, including angle and frequency.
Procedures for testing sync-check, synchronizing, and auto-synchronizing relays.
Configuring settings for power relay tests, including tap and time dial values.
Configuring settings for reclose relays, including operations and times.
Configuring settings for frequency relay tests, including tap and frequency values.
Performing manual tests involving voltage and current outputs for relays.
Executing transducer tests and viewing results.
Step-by-step guide for conducting transducer tests.
Guidance on troubleshooting and servicing the MPRT unit.
Steps and requirements for performing calibration checks on the unit.
To Next Page
