vi VM600 MPS quick start manual MAMPS-QS/E
Edition 2 - October 2018
Applicability of the manual
This manual applies to a VM600 machinery protection system (MPS) using the new
generation of VM600 MPC4 cards (hardware versions 03x, 11x, 21x and subsequent
models). These later cards are easily distinguished from earlier models as they have seven
LEDs on their panels, whereas previous versions (01x and 02x) had only one LED (identified
as DIAG). Users of systems having earlier versions of the MPC4 card should refer to an
earlier edition of this manual.
Please note that this manual describes use of the VM600 MPSx software with a standard
Microsoft
®
Windows
®
configuration in English. If using a different locale, you may need to
modify certain parameters, for example, use a comma (“,”) as the decimal mark in numbers.
Related publications and documentation
For further information on the use of a VM600 machinery protection system (MPS), refer to
the following Meggitt Sensing Systems (MSS) documentation:
• VM600 machinery protection system (MPS) hardware manual
(MSS document ref. MAMPS-HW/E)
• VM600 MPS1 configuration software for machinery protection systems software manual
(MSS document ref. MAMPS1-SW/E)
• VM600 MPS2 configuration software for machinery protection systems software manual
(MSS document ref. MAMPS2-SW/E).
• IRC4_configurator for intelligent relay cards software manual
(MSS document ref. MAIRC4-SW/E).
Operators of networked VM600 racks should also refer to the following document:
• VM600 networking manual
(MSS document ref. MAVM600-NET/E).
Operators of safety-related systems (SRSs) should also refer to the following document:
• VM600 safety manual
(MSS document ref. MAVM600-FS/E).
For information on the use of a VM600 condition monitoring system (CMS), refer to the
following Meggitt Sensing Systems (MSS) documentation:
• VM600 condition monitoring system (CMS) hardware manual
(MSS document ref. MACMS-HW/E).
To Next Page
Loading...
Need help?
General
