Melco EP 1 - Audio Feedback Settings

5-2
EP 1 Operation Manual Melco Embroidery Systems
Key Click Volume
Each time you press one of the keys on the EP 1 control panel, the machine responds with a
“click” sound. You can adjust the volume of this click to suit your needs.
1. With the machine power OFF, hold down the [ALT] and [ò] keys and keep holding them down
while you turn the power ON and the display will read UNIT NUMBER _ _.
2. Press the [ò] twice and the display will read: KEY CLICK.
3. Press [ENTER] and the display will read: KEY CLICK 30.
4. Change the key click volume by pressing the [ñ] or [ò] keys until the desired volume is
obtained.
5. Press [ENTER] until the display reads: MEMORIZE & EXIT.
6. Press [ENTER] again to “save” the click volume.
7. Turn the machine power OFF, wait a few seconds, then turn it back ON. When the machine
powers up, the key click volume remains at the new level.
NOTE: If the power is turned off before completing this procedure, the setting will not be saved.
Error Beep Volume
Whenever an operation error occurs, the EP 1 beeps. The volume of this beep can be adjusted to
suit your needs.
1. With the machine power OFF, hold down the [ALT] and [ò] keys and keep holding them down
while you turn the power ON and the display will read UNIT NUMBER _ _.
2. Press the [ò] three times and the display will read: ERROR BEEP.
3. Press [ENTER] and the display will read: ERROR BEEP 30.
4. Change the error beep volume by pressing the [ñ] or [ò] keys until the desired volume is
obtained.
5. Press [ENTER] until the display reads: MEMORIZE & EXIT.
6. Press [ENTER] again to “save” the beep volume.
7. Turn the machine power OFF, wait a few seconds, then turn it back ON. When the machine
powers up, the error beep volume remains at the new level.
NOTE: If the power is turned off before completing this procedure, the setting will not be saved.