Melitta BARISTA TS SMART - Filling with coffee beans and using Bean Select

Basic operation
46
GB
Filling with coee beans
1. Open the lid of the 2-chamber bean
container(2).
2. Fill coee beans into the bean cham-
bers.
3. Close the lid of the 2-chamber bean
container.
The "BEANSELECT" button (30)
(BARISTATS model) or the "BeanSelect"
slider (3)(BARISTAT model) can be used
to select a bean type prior to preparation
(see section5.6, page49).
4.6 Using ground coee
Ground coee may also be used to pre-
pare coee beverages.
ATTENTION
The use of unsuitable types of coee can
lead to clogging of the brewing unit.
 Do not use any instant products.
 Fill a maximum of one coee spoon of
ground coee into the ground coee
chute.
4
Fig. 10: Ground coee chute
1. Open the lid of the ground coee
chute(4).
2. Use the enclosed coee spoon for
dosing.
Fill a maximum of one coee spoon of
ground coee into the ground coee
chute.
3. Close the lid of the ground coee
chute.
4. Proceed as described in sections 5 to 7.
Information
ū Two-cup dispensing is not possible
when using ground coee.
ū If no coee is prepared within 3
minutes of opening the ground coee
chute, the appliance switches to opera-
tion with coee beans and the ground
coee is discharged into the coee
grounds container.
4.7 Filling with water
Only use fresh, cold water without carbon
dioxide for optimum coee enjoyment.
Change the water daily.
Information
The quality of the water largely determines
the avour of the coee. Therefore, use a
water lter (see section9.8, page60 and
section9.9, page60).
1
Fig. 11: Water tank
1. Open the lid of the water tank and pull
the water tank (1) upwards out of the
appliance by the handle.
2. Fill the water tank with water.
Note the maximum capacity of 1.8
litres.
3. Insert the water tank into the appliance
from above and close the lid.