Requirement: The appliance is ready for
operation.
1. Place a vessel beneath the outlet.
2. Press the "menu/ok" button for 2sec-
onds.
» The menu appears on the display.
3. Navigate to the Care > Rinsing menu.
4. Use the arrow buttons to select Start
and conrm with "menu/ok".
» The coee system is rinsed.
» The appliance is ready for operation.
9.3 Cleaning the brewing unit
To avoid damage to the appliance, we
recommend cleaning the brewing unit
once a week.
11
Fig. 20: Removing the brewing unit, 1
14
44
Fig. 21: Removing the brewing unit, 2
45
Fig. 22: Cleaning the brewing unit
Requirement: The appliance is switched
o.
1. Open the cover (11). To do this, reach
into the recess on the right of the appli-
ance and pull the cover o upwards.
2. Press and hold the red lever(44) on the
brewing unit handle(14) and turn the
handle clockwise until it engages at the
stop.
3. Pull the brewing unit out of the appli-
ance by the handle.
4. Rinse the entire brewing unit thor-
oughly from all sides under running
water. In particular, make sure that
coee residues are removed from the
sieve(45).
5. Allow the brewing unit to drip dry.
6. Use a soft, dry cloth to remove coee
residues from the surfaces inside the
appliance.
7. Insert the brewing unit into the appli-
ance. Press and hold the red lever on
the handle of the brewing unit and turn
the handle counter anticlockwise until
it engages at the stop.
8. Close the cover. To do this, insert the
bottom of the cover into the appliance
and swing it up until it engages.
9.4 "Easy Cleaning"
programme
The milk system is rinsed using the "Easy
Cleaning" programme.
Each time after a beverage has been
prepared with milk, the appliance requests
you to execute the "Easy Cleaning" pro-
gramme.
To Next Page
Loading...
Need help?
General
