Melitta Cafina XT4 - 5 Operation; Switching the Machine on and off; Switching on; Stand-By Operation

5 Operation
Inial commissioning is carried out by customer service.
If you want to put the machine back into operaon
following a standsll, clean the machine as described
(see chapter 8 on page 27).
5�1 Switching the machine on and off
5�1�1 Switching on
000494
1
2
3
Fig. 3: Switching on the machine
1. Check that the water supply is on.
2. Open the machine door (3) using the key (1).
3. Switch the machine on using the main switch (2).
4. Close the machine door.
5. Continue as described in chapter 5.1.2 on page 10.
Note
The main switch can be used to switch the
machine off entirely, e.g., during extended
standstills.
5�1�2 Stand-by operation
In daily operation, it is sufficient to switch the machine
on and off via the display only (stand-by operation):
1. Touch the display.
͵ If required, you have to enter a password first
(see chapter 7.1.2 on page 21).
The button to switch on the unit is shown on the display.
000464
2
1
Fig. 4: Switching on the machine
2. Press the button (2).
Note
By pressing the button “Configuration” (1),
you can set up the machine even when it is
switched off.
The switch-on process is started and takes several
minutes.
CAUTION
Danger of burns on the beverage outlet!
Hot water runs out of the beverage outlet when the lines
are rinsed.
• Do not reach underneath the outlets.
͵ The lines are rinsed.
͵ The machine is heated to the required tempera-
ture.
͵ The required pressure is built up in the steam
boiler.
Once the switch-on process has finished, the products
that can be dispensed are listed on the display.
9 The machine is ready for operation.
Note
After switching on the machine, the filling levels
of the supply containers must be checked. If
necessary, the supply containers must be filled
and the filling levels confirmed.
Operation
10
35878 • 20201001
5