6. Press the “OK” button (1) to confirm that the
machine has been prepared for the cleaning of the
milk system.
͵ The machine starts the automatic cleaning pro-
cess.
͵ The cleaning process takes a few minutes.
7. Continue as described in chapter 8.7.4 on page 31.
8�7�3�2 Cleaning with AMC cleaner
If the system indicates to use the AMC cleaner, clean the
machine as described in chapter 8.7.3.1 on page 30;
however, instead of a cleaning tablet, fill a bag of AMC
cleaner into the cleaning container.
8�7�4 Cleaning the brewing system
To prepare the brewing system for the cleaning, the
machine performs a pre-rinsing.
Afterwards the prompt “Cleaning tablet inserted?” is
shown on the display.
Fig. 44: Cleaning tablet
1. Open the flap (1).
2. Insert a cleaning tablet into the chute.
3. Close the flap.
4. Press the “OK” button to confirm that the cleaning
tablet has been added.
͵ The machine starts the automatic cleaning pro-
cess.
͵ The cleaning process takes a few minutes.
Note
The touch screen can be cleaned while the
cleaning program is running without the need
to deactivate the display for inputs beforehand
(see also chapter 8.12 on page 35).
The machine is then switched off or, depending on the
selection, it goes back to operational readiness mode.
8�7�5 Final activities
1. Clean the dispensing area once the automatic
cleaning process is complete (see chapter 8.13 on
page 35).
2. If you want to continue using the machine, refill the
milk as described in chapter 5.2.3 on page 13.
9 The cleaning is complete.
Cleaning
31
35878 • 20201001
8
To Next Page
Loading...
