To simplify filling, the relevant container can be removed.
1
2
Fig. 7: Removing the bean container
1. Remove the lid on the bean container.
2. Turn the lever (1) a ¾ turn counterclockwise.
3. Remove the bean container (2).
4. Fill the coffee beans into the bean container.
5. Refit the bean container back into the machine.
6. Turn the lever a ¾ turn clockwise back to the original
position.
7. Refit the lid.
9 The bean container has been filled.
Note
The coffee grounds drawer should also be
emptied every time the coffee supply is filled
(see chapter 5.5 on page 15).
5�2�2 Filling the instant powder (option)
ATTENTION
Damage to the instant container cover!
The lid on the instant container cover cannot be removed.
Trying to remove the lid could damage the cover. Only
open the container cover with the machine key.
Fig. 8: Opening the instant container cover
1. Open the machine door using the key (2).
2. Lift the instant container cover (1) upwards carefully.
There will be one or two instant containers depending
on the equipment.
1
2
Fig. 9: Instant container
3. Turn the powder chute (2) upwards so that no
powder can fall out.
4. Remove the instant container (1).
5. Remove the lid on the instant container.
6. Fill the right instant powder into the corresponding
container, e.g., cocoa.
͵ Ensure that the powder is not compressed.
7. Refit the lid.
8. Refit the instant container.
Operation
12
35878 • 20201001
5
To Next Page
Loading...
