25
Starting up the appliance
Operating Instructions: Melitta
®
CI
®
|
1834-0618 | 2018-08
GB
Starting up the appliance
Switching on for the fi rst time
WARNING
Danger of fi re and electric shock
due to incorrect supply voltage,
incorrect or damaged connections
and power cable!
▶ Ensure that the supply voltage
corresponds to the supply voltage
specifi ed on the identifi cation label of
the appliance. The identifi cation label is
located on the right side of the appliance
behind the cover (Figure B, 13).
▶ Make sure that the power socket meets
the applicable standards for electrical
safety. If in doubt, contact a qualifi ed
electrician.
▶ Never use damaged power cables
(damaged insulation, bare wires).
■ Place the appliance on a stable, dry and
level surface with suffi cient clearance
(at least 10 cm) to the sides.
■ Plug the power cable into a suitable
power socket.
■ Press the
button to switch on the
appliance.
After switching on, fi rst set the language
and then the time.
■ Turn the rotary switch (Figure A, 10)
to selective the respective setting
(language, hour, minute).
■ Press the rotary switch to save the each
setting.
After making the settings, fi ll the bean
container:
■ Filling the bean container (Page 26).
Then fi ll the water tank:
■ Lift up the lid of the water tank 6 and
pull the water tank up and out of the
appliance.
■ Fill the water tank with fresh tap water
only up to the max. mark.
■ Insert the water tank into the appliance.
■ Press the rotary switch.
■ Place a vessel under outlet 3.
■ Press the rotary switch. First, an
automatic rinsing is carried out.The
appliance is ready for operation when
the buttons illuminate.
To Next Page
Loading...
