Melitta CI Touch User Manual

Care and maintenance
49
GB
Requirements:
 The appliance is ready for operation.
 A container (0.7l) is placed beneath the
spout.
1. Press the "rotary switch" for 2 seconds.
» The menu appears on the display.
2. Navigate to the Care > Descaling menu.
3. Select Start and conrm your selection.
4. Follow the further instructions on the
display up to the end of the descaling
programme.
9.8 Setting the water hardness
The set water hardness inuences the fre-
quency of descaling. The harder the water,
the more frequently the appliance has to
be descaled.
Information
The water hardness cannot be set if you
use a water lter.
Determine the water hardness with the
enclosed test strip. Observe the instruc-
tions on the test strip packaging and
table11, page51.
Requirement: The appliance is ready for
operation.
1. Press the "rotary switch" for 2 seconds.
» The menu appears on the display.
2. Navigate to the
Settings > Water hardness menu.
3. Select the water hardness range and
conrm your selection.
9.9 Using a water lter
The use of a water lter extends the ser-
vice life of the appliance and the appliance
has to be descaled less frequently. The
water lter contained in the scope of deliv-
ery lters calcium and other pollutants out
of the water.
1
37
38
39
Fig. 18: Screwing/unscrewing the water
lter
The water lter(38) is screwed into and
unscrewed from the thread(37) on the
base of the water tank(39) using the
screwing aid at the end of the enclosed
coee spoon(1).
Inserting the water lter
Information
Place the water lter into a vessel lled
with fresh tap water for a few minutes
before inserting it.
Requirements:
 The appliance is ready for operation.
 A container (0.7l) is placed beneath the
spout.
1. Press the "rotary switch" for 2 seconds.
» The menu appears on the display.
2. Navigate to the Care > Filter > Insert
lter menu.
3. Select Start and conrm your selection.
4. Follow the further instructions on the
display.
» The water hardness is automatically
adjusted on the water lter by the
appliance.
» The appliance is ready for operation.

Melitta CI Touch Specifications

General

Product type	Espresso machine
Capacity in cups	- cups
Hot water system	Yes
Milk adding type	Pipe
Number of spouts	2
Coffee input type	Coffee beans, Ground coffee
Coffee maker type	Fully-auto
Appliance placement	Countertop
Water tank capacity	1.8 L
Maximum operating pressure	15 bar
Reservoir for brewed coffee	Cup
Control type	Touch
Display type	TFT
Product color	Black
Pallet width	800 mm
Pallet height	1821 mm
Pallet length	1200 mm
Pallet weight	215000 g
Package depth	387 mm
Package width	419 mm
Package height	571 mm
Package weight	11560 g

Weight and Dimensions

Depth	352 mm
Width	252 mm
Height	473 mm