Changing basic settings
40
GB
» The 2 cups display lights up.
3. Press a direct key.
» The grinding process and beverage
dispensing start.
» Beverage dispensing ends automat-
ically.
4. Remove both vessels.
Information
The setting only applies to the single
beverage that is prepared.
If a coee beverage is not prepared
within 1 minute, the appliance switches
to single-cup dispensing.
6 Changing basic settings
You can change the basic settings of the
appliance with several functions. The func-
tions are divided into two service modes.
6.1 Service mode 1
Each function is assigned a display.
Service mode 1
Display function
Auto OFF
Water hardness
Switch-o rinsing
Filter programme
Cleaning programme
Descaling programme
Brewing temperature
To call up Service mode1, proceed as
follows:
Requirement: The appliance is ready for
operation.
1. Press the "Service" button for
more than 2seconds to call up Service
mode1.
» The Ready display ashes
rapidly and the 2 cups button lights
up.
2. Press the "Service" button one or
more times to access the desired
function.
» A display lights up according to the
function selected, see Service mode1
table.
» The number of lit bean symbols
indicates the current setting of the
function.
Press the "Coee" direct key to exit the
service mode without saving the settings.
Information
If no further input is made within 1min-
ute, the appliance returns to Ready mode.
6.2 Setting Auto OFF
If you do not operate the machine for a
long time, it initially switches to energy
save mode. After a further preset time, the
appliance switches o.
The following settings are possible:
Display Energy save
mode after:
Switch o after:
3 minutes 30 minutes
10 minutes 1 hour
20 minutes 4 hours
ash
30 minutes 8 hours
Information
Press any button to exit Energy Save
mode.
Requirement: The appliance is ready for
operation.
1. Press the "Service" button for
more than 2seconds to call up Service
mode1.