Melitta Purista - Transport, Storage, and Disposal; Permanently De-registering the Water Filter; Venting the Appliance

Transport, storage and disposal
49
GB
Requirement: The appliance is ready for
operation.
1. Press the "Service" button for
more than 2seconds to call up Service
mode1.
2.  Press the "Service" button
repeatedly unit the display for the lter
programme appears.
» One bean lights up.
3. Press the "Service" button for
more than 2seconds to start the lter
programme.
» The Filter display ashes until the
lter programme is nished.
» The Drip tray display lights up
and requests you to empty the drip
tray and the coee grounds
container.
4. Empty the drip tray and the coee
grounds container.
5. Insert the drip tray without the coee
grounds container.
6. Place the coee grounds container
beneath the outlet.
» The Water display lights up and
requests you to remove the water
tank and insert the water lter.
7. Remove the water tank.
8. Empty the water tank.
9. Insert a new lter in the water tank (see
Fig. 15).
10. Fill the water tank.
11. Insert the water tank again.
» The lter is rinsed with water.
» Water ows into the drip tray.
12. Empty the drip tray and the coee
grounds container.
13. Insert the drip tray and the coee
grounds container.
» The lter programme is nished.
» The Filter display goes out.
» The appliance is ready for operation.
Permanently de-registering the water
lter
If you have removed an inserted water
lter and want to continue operating the
appliance without a water lter, deactivate
the water lter on the appliance:
1. Remove the water tank.
2. Empty the water tank.
3. Remove the water lter (see Fig. 15).
4. Fill the water tank.
5. Insert the water tank again.
6. Press the "Service" button for
more than 2seconds to call up Service
mode1.
7.  Press the "Service" button
repeatedly until the display for the Filter
function appears.
8. Press the "Coee strength" button
repeatedly until no coee beans are lit.
9. Press the "Service" button for
more than 2seconds to save the
setting and exit the service mode.
» The water lter is de-registered.
» The water hardness is reset to the
water hardness that the appliance
had stored prior to inserting a water
lter.
10. Adjust the water hardness if necessary
(see section.6.3 Setting the water hard-
ness on page41).
8 Transport, storage and
disposal
8.1 Venting the appliance
We recommend venting the appliance
when it is not used for a long period, prior
to transport and when there is a risk of
frost.
During venting, residual water is removed
from the appliance.
If you put the appliance back into opera-
tion, automatic rinsing is carried out after
switching on and the appliance vented