41
Duplicating a video tape
1
Load a blank cassette tape with the erase
prevention tab intact into the recording unit.
Load a previously recorded tape into the playback
VCR or CAMCORDER.
2
Press SPEED to select the desired tape speed
SP or SLP.
It is recommended that you set the speed to the
SP mode on the recording unit for best results.
3
Press INPUT SELECT to select AUDIO/VIDEO
input position. “LINE” will appear on the screen.
4
Press REC/OTR on the recording unit, then press
PAUSE/STILL.
5
Press the PLAY button on the playback VCR or
CAMCORDER, then press the PAUSE/STILL
button.
6
Release the recording pause and the playback
still simultaneously to begin the duplicating
process.
For duplicating a previously recorded tape from a
camcorder, follow the camcorder manufacturer’s
instructions. A typical camcorder dubbing hookup is
shown above.
Connection with second Video recorder
Connection with Video camera
Duplicating a video tape
If you connect the unit to another VCR or camcorder, you can duplicate a previously recorded tape.
Make all connections before turning on the power.
To AUDIO (R) IN
To AUDIO (L) OUT
AUDIO/VIDEO
Cord (not supplied)
Playback VCR
To VIDEO OUT To AUDIO (R) OUT
To VIDEO IN
To AUDIO (L) IN
Recording unit
AUDIO/VIDEO Cord (not supplied)
To AUDIO (R) IN
To AUDIO (L) IN
To VIDEO IN
Recording unit
To AV Jack
Playback Camcorder
5V40401A [En]40-41 2/3/06, 6:00 PM41
To Next Page
Loading...
