Mendota ML60 - Mechanical Technical References

85-03-01147 ML60 Page 13
4.2 MECHANICAL TECHNICAL REFERENCES
Planning the installation
This Mendota Fireplace must be installed and serviced by a qualified installer, service agency, or the gas supplier.
When planning on appliance installation, it is necessary to determine the following information before installing:
• Where the appliance is to be installed.
• The vent system configuration to be used.
• Gas supply piping.
• Electrical Wiring.
• Framing and finishing details.
• Hearth Protection Pad Requirements.
• Whether accessories such as a ceiling fan are desired.
Selecting Appliance Location
When selecting a location for your appliance, it is important to consider the required clearances to walls.
Figure 4-1 FIREPLACE LOCATION
WARNING
FIRE RISK- ODOR RISK
• Install appliance on hard metal or wood surfaces extending full width and depth of this fireplace.
• Do NOT install this fireplace directly on carpeting, vinyl or any combustible material other than wood.
Construct chase to all clearance specifications in manual.
• Locate and install appliance to all clearance specifications in manual.