85-03-01147 ML60 Page 30
Option 1: Installing Front On Top Of Finishing Material
Note: No extra parts required. Option 1 employs the inner guides that are factory installed.
Option 1 requires that your finish material be less than 2.5” thick, including backing materials and reasonably flat. If your finish
material thickness exceeds 2.5” then consider using Option 3 Guides, see “Option 3.
Otherwise, use the inner guides that come installed on the fireplace. The guides are 1” deep.
If your finish material is rough or lightly colored and extends past 1”, you may be able to see the material behind the screen at
certain angles.
After the fireplace is installed and the finishing material installation is complete the decorative front can be hung on the
fireplace. The finished look is like hanging a picture frame on a wall where the frame protrudes out from the wall.
Because the screen is attached to the back of the Grace front, there will be a ¾” gap between the frame and wall. If you do not
want this gap but want the frame to mount over the finishing material, then consider using Option 2.
To Next Page
Loading...
