Key Functions
Engineer’s Reset
1. Enter the Engineer’s Code default 1234. You
are now in Engineer’s Mode.
2. Press 0 to return to unset.
Loading Defaults
1. Power down panel mains and battery.
2. Place a small screwdriver blade between the
pins on the control panel PCB, marked Factory
Restart.
3. Power up panel battery and mains.
4. Remove screwdriver.
5. Enter 1234 to silence alarm.
6. The system will have reverted back to Factory
Default Programming.
Bell Test/ Walk Test
Please refer to user’s menu numbers 1 and 2
respectively.
496522 Issue A 7of10 TS400 & TS410
TS400 & TS410
To Next Page
Loading...
