Merck Milliflex Oasis - Table of Contents

Page 2 of 24
Notice
The information provided in this document (or any other literature) is subject to change without prior notice
and shall not constitute a commitment of Merck KGaA, Darmstadt, Germany or any of it’s Aliates. Merck
KGaA, Darmstadt, Germany or any of it’s Aliates expressly decline all warranties and shall not assume any
responsibility for any errors that may appear in this document. This manual is believed to be complete and
accurate at the time of publication. In no event shall Merck KGaA, Darmstadt, Germany or any of its Aliates be
liable for all damages (including but not limited to incidental or consequential damages) in connection with, or
arising from, the use of this document or associated literature.
Table of Contents
Introduction 3
1. Components 4
1.1 Required items 4
1.2 Description of items 5
1.3 Touch switch 6
2. Hardware installation 7
3. Testing 9
3.1 Filtration units 9
3.2 Media plates 9
3.3 Testing 9
3.4 Waste 10
4. Cleaning & maintenance 11
4.1 Cleaning & maintenance table 11
4.2 Surface sanitizers and internal ow
sanitizers table 11
4.3 Filtration head cleaning 12
4.4 Pump surface cleaning 12
4.5 Pump rinsing 12
4.6 Filtration head external gasket cleaning 12
4.7 Pump internal ow sanitization 13
4.8 Filtration head complete cleaning 14
4.9 Filtration head gaskets and check valve
(spare parts) replacement 15
4.10 Sanitization kit gaskets and valve
(spare parts) replacement 16
5. Performance verication 17
6. Use of multiple pumps 18
6.1 Material needed 18
6.1.1 Two pumps connected 18
6.1.2 Three pumps connected 18
6.2 Installation 18
7. System specications 20
8. Ordering information 21
9. Troubleshooting 23
10. Operator & equipment safety instructions 23
11. Technical assistance 23