EasyManuals Logo

MerCruiser 350 MAG MPI User Manual

MerCruiser 350 MAG MPI
150 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #145 background imageLoading...
Page #145 background image
Section 7 - Troubleshooting
90-864195070 JUNE 2007 Page 137
Power Trim Does Not Operate (Motor Does Not Operate)
Possible Cause Remedy
Blown fuse.
Replace fuse. Fuses may be located near the dash
trim switch, at the trim pump, in the positive (red)
power trim battery lead near the battery switch, or a
combination of these.
Loose or dirty electrical connections or damaged
wiring.
Check all associated electrical connections and wires
(especially battery cables). Clean and tighten faulty
connection. Repair or replace wiring.
Power Trim Does Not Operate (Motor Operates But Sterndrive Unit
Does Not Move)
Possible Cause Remedy
Trim pump oil level low. Fill pump with oil.
Drive unit binding in gimbal ring. Check for obstruction.

Table of Contents

Other manuals for MerCruiser 350 MAG MPI

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MerCruiser 350 MAG MPI and is the answer not in the manual?

MerCruiser 350 MAG MPI Specifications

General IconGeneral
Engine TypeV8
Horsepower300 HP
Ignition SystemElectronic ignition
Alternator65 amp
Compression Ratio9.4:1
Displacement5.7L (350 cu in)
Fuel SystemMulti-Point Injection (MPI)
Bore x Stroke4.00" x 3.48" (101.6mm x 88.39mm)

Related product manuals