MerCruiser 350 MAG MPI User Manual

Section 5 - Maintenance
Page 88 90-864195070 JUNE 2007
Shift Cable ‑ Typical
1. Lubricate the pivot points and the guide contact surfaces.
mc79736
a
b
a - Pivot points b - Guide contact surfaces
Tube Ref. No. Description Where Used Part No.
Synthetic Blend MerCruiser Engine
Oil SAE25W‑40
Shift cable pivot points & guide
contact surfaces
92‑883725K01
Sterndrive Unit and Transom Assembly
1. Lubricate gimbal bearing by applying approximately 8‑10 pumps of grease from a
typical hand‑operated grease gun.
mc77068-1
a
a - Gimbal bearing grease fitting
Tube Ref No. Description Where Used Part No.
42
U-joint and Gimbal Bearing
Grease
Gimbal bearing 92-802870A1
2. For propeller shaft lubrication, refer to Propellers.

MerCruiser 350 MAG MPI Specifications

General

Engine Type	V8
Horsepower	300 HP
Ignition System	Electronic ignition
Alternator	65 amp
Compression Ratio	9.4:1
Displacement	5.7L (350 cu in)
Fuel System	Multi-Point Injection (MPI)
Bore x Stroke	4.00" x 3.48" (101.6mm x 88.39mm)