Mercury 10 EFI FourStroke - Page 121

INSTALLING OUTBOARD ON TRANSOM
!
WARNING
Failure to correctly fasten the outboard could result in the outboard propelling
off the boat transom resulting in property damage, serious injury, or death.
Before operation, the outboard must be correctly installed with the required
mounting hardware.
This product must be secured to the transom with the required mounting
hardware. If the outboard strikes an underwater object, the required mounting
hardware prevents the outboard from propelling off the transom. A decal on the
swivel bracket reminds the installer of the potential hazard.
Avoid serious injury
or death. Secure
engine to transom
with bolts.
WARNING
37-896853-007
52375
1. Place the outboard on the centerline of the transom.
27005
2. Tighten the transom bracket clamp screws to the specified torque.
28501
Description
Nm lb‑in. lb‑ft
Transom bracket clamp screws 13.5 120 –
ENGINE INSTALLATION
eng 111