1. Route the hoses, wiring, and cables through the rigging adapter and
correct opening in the rigging grommet as shown.
a - Screw (2)
b - Rigging adapter
c - Rigging grommet
d - Speedometer tube opening
e - Remote 14 pin boat harness opening
f - Battery cable opening
g - Accessory harness opening
h - Shift cable opening
i - Fuel hose opening
j - SmartCraft harness or additional harness opening
k - Throttle cable opening
2. Fasten the rigging grommet and rigging adapter with two screws. Tighten
the screws to the specified torque.
3. Hold the wiring, hoses, and cables together with a cable tie.
To Next Page
Loading...
