Mercury 225 HP User Manual

225 (4-STROKE) INSTALLATION MANUAL
Page 7 of 16
Front Cable Clamp Assembly
IMPORTANT: Sufficient slack must exist in engine wiring harness, battery cables,
and fuel hose routed between cable clamp and engine attachment point, to relieve
stress.
1. Bundle the fuel line, battery cables and wiring together and wrap with the piece of foam
(provided) as shown. Secure the wiring, battery cables, fuel line and foam together with
sta-straps.
2. Push the flap (a) down over the top of the shift and throttle cable.
3. Lay the wrapped foam over the top of flap.
a
b
c
d
a-Shift and throttle cables
b-Flap - Position over the shift and throttle cables
c-Foam
d-Sta-Straps

Mercury 225 HP Specifications

General

Engine Type	V6
Displacement	3.4L
Full Throttle RPM	5000-5800
Fuel Induction System	Electronic Fuel Injection (EFI)
Starting	Electric
Gear Ratio	1.85:1
Horsepower	225 HP
Cylinders	6
Exhaust	Through Prop
Steering	Hydraulic
Shaft Length	20 in / 25 in / 30 in
Weight	505 lbs (229 kg)