FUEL & OIL
eng 59
Oil Recommendation
Recommended Oil
Mercury or Quicksilver Premium 2‑Cycle TC‑W3
Outboard Oil
IMPORTANT: Oil must be NMMA certified TC‑W3 2‑Cycle oil.
Mercury or Quicksilver Premium TC‑W3 2‑Cycle oil is
recommended for this engine. For added protection and
lubrication, Mercury or Quicksilver Premium Plus TC‑W3 2‑Cycle
oil is recommended. If Mercury or Quicksilver outboard oil is not
available, substitute another brand of 2‑cycle outboard oil that is
NMMA Certified TC‑W3. Severe engine damage may result from
use of an inferior oil.
Mixing Fuel and Oil
Use a 25:1 (4%) gasoline/oil mixture in the first tank of fuel.
After the break‑in fuel mixture is used up, use a 50:1 (2%)
gasoline/oil mixture. Refer to the table (following) for mixing
ratios.
GASOLINE/OIL MIXING RATIO CHART
GASOLINE/OIL MIXING RATIO CHART
Gas/Oil Ratio
3.8 liters (1 gal.)
gas
11.5 liters (3 gal.)
gas
23 liters (6 gal.)
gas
25:1 (4%)
148 ml (5 fl. oz.)
oil
473 ml (16 fl. oz.)
oil
946 ml (32 fl. oz.)
oil
50:1 (2%)
89 ml (3 fl. oz.) oil 237 ml (8 fl. oz.) oil
473 ml (16 fl. oz.)
oil
MIXING PROCEDURE
Pour the full amount of oil along with approximately one gallon of
gasoline into an approved container. Shake the two together until
they are thoroughly mixed. Add the remainder of gasoline and
shake container to ensure mixing.
To Next Page
Loading...
