OPERATION
eng 73
Remote control
models
a - Hook
b - Off
c - On
d - Lanyard stop
switch
NOTE: The engine will not start unless this switch has been
properly connected and locked beforehand. Refer to
General
Information
‑
Lanyard Stop Switch
.
STARTING THE ENGINE
1. Pull the rewind starter slowly until you feel the starter
engage, then pull rapidly to crank the engine. Allow the rope
to return slowly.
a - Slowly
b - Rapidly
IMPORTANT: Before starting, read the Pre‑Starting Check List,
Special Operating Instructions, and Engine Break‑in Procedures
in the Operation section.
2. Tiller handle models: Push the starter button.
To Next Page
Loading...
