Mercury 25 2-Stroke - Page 84

OPERATION
74 eng
3. After the engine starts, release the button.
37524
4. Remote control models: Insert, push, and turn the key to the
start position.
NOTE: When restarting a warm engine, do not push the key;
merely turn it to the start position.
a - On
b - Start
5. When the engine starts, release the key, and it will return
automatically to the run position.
6. If the engine fails to start in 10 seconds, wait 30 seconds
and try again. If the engine begins to stall, reprime (push key
in) until the engine is running.
37717
a
b