EasyManua.ls Logo

Mercury 25 2-Stroke - Spark Plug Inspection and Replacement

Mercury 25 2-Stroke
131 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MAINTENANCE
eng 87
2. Lift rear of cowl and disengage front hook.
26851
INSTALLATION
1. Engage the front hook and push cowl back over the cowl
seal.
2. Push cowl down and move the rear latch lever up to lock.
Battery Inspection
The battery should be inspected at periodic intervals to ensure
proper engine starting capability.
IMPORTANT: Read the safety and maintenance instructions
which accompany your battery.
1. Turn off the engine before servicing the battery.
2. Ensure the battery is secure against movement.
3. Battery cable terminals should be clean, tight, and correctly
installed. Positive to positive and negative to negative.
4. Ensure the battery is equipped with a nonconductive shield
to prevent accidental shorting of battery terminals.
Fuel System
!
WARNING
Fuel is flammable and explosive. Ensure that the key switch is
off and the lanyard is positioned so that the engine cannot
start. Do not smoke or allow sources of spark or open flame in
the area while servicing. Keep the work area well ventilated
and avoid prolonged exposure to vapors. Always check for
leaks before attempting to start the engine, and wipe up any
spilled fuel immediately.

Table of Contents

Related product manuals