OPERATION
70 eng
2. Loosen the air vent screw on the tank cap. For tanks with a
fuel tank auto air vent (optional): There is no need to loosen
the air vent screw. An air vent opens automatically when the
connector is attached to the tank.
3. Feed fuel to the carburetor by squeezing the primer valve
until firm.
a - To fuel tank
b - To outboard
c - Fuel flow direction
NOTICE
Without sufficient cooling water, the engine, the water pump,
and other components will overheat and suffer damage.
Provide a sufficient supply of water to the water inlets during
operation.
4. Tiller handle models: Set the shift lever to neutral position.
NOTE: Be sure that the shift is at Neutral (N) when starting the
engine. This model is provided with start in gear protection.
5. Turn the throttle grip until the bar mark on the grip faces the
triangle mark on the steering handle.
To Next Page
Loading...
