1. Move the remote control handle from neutral into forward and advance
the handle to full speed position.
NOTE: The throttle cable is the second cable to move when moving the
control box out of neutral.
2. Install the throttle cable to the throttle actuating lever. Secure with a
washer and cotter pin retainer.
3. Adjust the throttle cable barrel, so when barrel is installed into the throttle
cable barrel support, no play can be felt when lightly pushing the throttle
cam with your finger.
a - Throttle cam (no play can be felt when lightly pushing)
b - Throttle cable barrel
c - Throttle actuating lever
4. Slowly return the remote control handle back to the neutral detent
position.
5. Inspect the cam roller to ensure it is not contacting the cam.
To Next Page
Loading...
