4. Fasten the outboard with provided mounting hardware shown. Tighten the
locknuts to the specified torque.
The outboard must be secured to the transom with the two transom bracket
clamp screws and four 13 mm (1/2 in.) diameter mounting bolts and locknuts
provided. Install two bolts through the upper set of mounting holes and two
bolts through the lower set of mounting slots.
a - Bolt (4)
b - Transom bracket clamp screws
c - Washer (4)
d - Locknut (4)
Description Nm lb‑in. lb‑ft
Outboard mounting locknuts and
bolts
75 – 55
Steering Bracket, Steering Cable Installation
1. Install the steering bracket with two washers and two 30 x 80 mm bolts.
Tighten the steering bracket bolts to the specified torque.
Description
Nm lb‑in. lb‑ft
Steering bracket bolt 30 – 22
2. Lubricate entire steering cable end with 2‑4‑C with PTFE.
Tube Ref
No.
Description Where Used Part No.
95
2-4-C with PTFE Steering cable end 92-802859A 1
3. Install the steering cable seal onto the end of the tilt tube.
To Next Page
Loading...
