Description Nm lb‑in. lb‑ft
Access cover bolt (3) 10 88 –
SHIFT CABLE INSTALLATION
!
WARNING
If not properly installed, the reverse gate can interfere with water coming off
the rudder, suddenly and unexpectedly slowing the boat. This can cause
serious injury or death from occupants being thrown within or out of the boat.
Adjust the shift cable to prevent the reverse gate from interfering with water
flow off the rudder.
1. Attach the shift cable to the shift cam with a flat washer and a self‑locking
nylon insert locknut as shown. Tighten the locknut against the flatwasher,
then back‑off the locknut 1/4 turn.
2. Place the remote control handle into full forward position.
3. Adjust the shift cable adjustment barrel so that the roller is at the full end
of travel (bottom) in the shift cam.
INSTALLATION
eng 97
To Next Page
Loading...
