TILTING OUTBOARD TO FULL UP POSITION
1. Stop the engine. Move the lock lever to the free position. Take hold of the
top cowl grip and raise the outboard to the full tilt up position. Lock the
outboard in place by moving the lock lever to the lock position.
2. Engage the tilt support lever.
3. Lower the outboard to rest on the tilt support lever.
LOWERING OUTBOARD TO RUN POSITION
1. Move the lock lever to the free position. Tilt up the outboard slightly and
release the tilt support lever. Lower the outboard to the run position.
2. Move the lock lever to the lock position.
OPERATING ANGLE ADJUSTMENT
The transom brackets have four holes for adjusting the vertical operating angle
(forward stop movement) of the outboard. Use the tilt pin for adjustments in the
four holes.
a - Transom bracket holes
b - Tilt pin
FEATURES AND CONTROLS
eng 29
To Next Page
Loading...
