IMPORTANT: To prevent engine flooding, do not squeeze the primer bulb
after engine has warmed up.
3.
Set the lanyard stop switch to the RUN position. Refer to General
Information ‑ Lanyard Stop Switch.
5. Move the neutral fast idle speed feature to the fully closed position.
NOTE: To start a flooded engine, advance the neutral fast idle speed feature
to the maximum fast idle speed position and continue to crank the engine for
starting. Immediately reduce engine speed after the engine starts.
6. Turn the ignition key to the START position. If the engine fails to start in
ten seconds, return the key to the ON position, wait 30 seconds and try
again.
To Next Page
Loading...
