Tube Ref
No.
Description Where Used Part No.
Extreme Grease Driveshaft bearing 8M0071842
95
2-4-C with PTFE Driveshaft bearing 92-802859A 1
• Driveshaft bearing
IMPORTANT: It is important not to use a general all‑purpose grease for this
bearing. The lubricant recommended is a water‑resistant grease of the proper
consistency for this application. If a substitute is used, be sure that it is
water‑resistant and of the same consistency.
i. Pull the vent hose off of the grease fitting.
ii. Pump in grease through the grease fitting, using the grease gun
provided, until excess grease starts to exit the vent hose.
iii. Reconnect the vent hose onto the grease fitting after greasing.
a - Grease fitting
b - Vent hose
NOTE: After 30 hours of operation, pump in extra grease to purge out any
moisture. Visually inspecting the purged grease at this time will give an
indication of conditions inside the bearing housing. A gradual increase in
moisture content, indicates seal wear. If the grease begins to turn dark or dirty
gray, the driveshaft bearing and seals should be inspected and replaced if
necessary. Some discoloration of the grease is normal during the break‑in
period on a new set of seals.
2. Lubricate the following with 2‑4‑C with PTFE or Extreme Grease.
Tube Ref
No.
Description Where Used Part No.
Extreme Grease
Swivel bracket, tilt tube, transom clamp
screws, steering cable grease fitting
8M0071842
95
2-4-C with PTFE
Swivel bracket, tilt tube, transom clamp
screws, steering cable grease fitting
92-802859A 1
To Next Page
Loading...
