30
og
FEATURES & CONTROLS
gog70
b
a
Power Trim And Tilt
Outboard position can be adjusted by pressing trim switch (a).
This range is used while operating your boat on plane.
• Pressing (DN): Moves the outboard in closer to the boat tran-
som, called trimming “in” or “down.”
• Pressing (UP): Moves the outboard further away from the boat
transom, called trimming “out” or “up.”
The term “trim”:
• Generally refers to the adjustment of the outboard within the first
20
° range of travel (b).
The term “tilt”:
• Generally refers to adjusting the outboard further up out of the
water.
With the engine turned off, the outboard can be tilted out of the wa-
ter. At low idle speed, the outboard can also be tilted up past the trim
range to permit, for example, shallow water operation.
(continued on next page)
To Next Page
Loading...
