Mercury 4-STROKE User Manual

Top Cowl Removal And Installation
REMOVAL
1. Pull out the front cowl latch.
4936
2. Lift front of cowl to clear front latch and push toward the rear to clear rear
hook.
3. Lift top cowl to remove.
INSTALLATION
1. Lower the top cowl into position over the engine.
2. Move the cowl toward the rear to align rear hook. After rear hook has
engaged, move cowl toward front and push down front of cowl.
3. Push in the latch to secure the top cowl.
Battery Inspection
The battery should be inspected at periodic intervals to ensure proper engine
starting capability.
IMPORTANT: Read the safety and maintenance instructions which accompany
your battery.
1. Turn off the engine before servicing the battery.
2. Ensure the battery is secure against movement.
3. Battery cable terminals should be clean, tight, and correctly installed.
Positive to positive and negative to negative.
4. Ensure the battery is equipped with a nonconductive shield to prevent
accidental shorting of battery terminals.
Exterior Care
Your outboard is protected with a durable baked enamel finish. Clean and wax
often using marine cleaners and waxes.
MAINTENANCE
82 eng

Mercury 4-STROKE Specifications

General

Engine Type	4-Stroke
Fuel Type	Gasoline
Cooling System	Water-cooled
Ignition System	CDI (Capacitor Discharge Ignition)
Starting	Manual / Electric
Shaft Length	15", 20", 25"
Max Power	Varies by model
Full Throttle RPM Range	Varies by model
Fuel Induction System	EFI / Carbureted
Steering	Remote / Tiller
Weight	Varies by model
Fuel Tank Capacity	Varies by model, some models include external tank
Oil Capacity	Varies by model