3. Straighten and remove the cotter pin.
4. Place a block of wood between the gearcase and propeller to hold the
propeller and remove the propeller nut.
5. Pull the propeller straight off the shaft. If the propeller is seized to the
shaft and cannot be removed, have the propeller removed by an
authorized dealer.
IMPORTANT: To prevent the propeller hub from corroding and seizing to the
propeller shaft (especially in saltwater), always apply the recommended
lubricant to the entire propeller shaft at the recommended maintenance
intervals and also each time the propeller is removed.
6. Apply Extreme Grease or 2‑4‑C with PTFE to the propeller shaft.
To Next Page
Loading...
