Mercury 40 4-Stroke - Page 80

OUTBOARD INSTALLATION
74
Tube Ref No. Description Where Used Part No.
95
2-4-C Marine Lubricant with
Teflon
Steering cable end 92-802859Q1
2. Insert the steering cable into the tilt tube.
28507
3. Tighten the nut to the specified torque.
29506
Description Nm lb. in. lb. ft.
Nut 47.5 35
STEERING CABLE SEAL
1. Mark tilt tube 6.4 mm (0.25 in.) from end. Install seal components.
2. Thread cap to the mark.
a
b
c
d
8041
a
a -
6.4 mm (1/4 in.)
b - Plastic spacer
c - O-ring seal
d - Cap