MAINTENANCE
94 eng
4. Before installing spark plugs, clean off any dirt on the spark
plug seats. Install plugs finger‑tight, and then tighten 1/4 turn
or torque to specifications.
Description Nm lb‑in. lb‑ft
Spark plug 27 20
Steering Pull Adjustment
The steering on some boats will have the tendency to pull
towards starboard. This pulling condition can be corrected by
using a pliers and bending the ends of the exhaust fins 1.5 mm
(1/16 in.) toward the starboard side of the outboard.
a - Exhaust fins
Worn/Dull Impeller
The intake of gravel through the pump can round off and wear
the leading edges of the impeller. Some conditions that could be
experienced from a worn/dull impeller are as follows:
• Noticeable performance loss, especially on acceleration
• Difficulty getting the boat on plane
• An increase in engine RPM at wide‑open throttle
IMPORTANT: Do not sharpen or alter the top side lifting angle.
To Next Page
Loading...
