MAINTENANCE
96 eng
Fuse Replacement
IMPORTANT: Always carry spare 20 amp fuses.
The electrical wiring circuits on the outboard are protected from
overload by fuses in the wiring. If a fuse is blown, try to locate
and correct the cause of the overload. If the cause is not found,
the fuse may blow again.
Open the fuse holder and look at the silver colored band inside
the fuse. If the band is broken, replace the fuse. Replace fuse
with a new fuse with the same rating.
a - Spare fuse slot
b - Diagnostic circuit 4 pin connector ‑ 2 amp fuse
c - SmartCraft data bus circuit ‑ 5 amp fuse
d - Main circuit ‑ 25 amp fuse
e - Spare 20 amp fuse
f - Main relay/accessories ‑ 15 amp fuse
g - Ignition coil circuit ‑ 20 amp fuse
h - Fuel pump/idle air control/fuel injector circuits ‑ 20 amp
fuse
i - Blown fuse
j - Good fuse
To Next Page
Loading...
