MAINTENANCE
eng 97
Timing Belt Inspection
1. Inspect the timing belt and have it replaced by an authorized
dealer if any of the following conditions are found.
a. Cracks in the back of the belt or in the base of the belt
teeth.
b. Excessive wear at the roots of the cogs.
c. Rubber portion swollen by oil.
d. Belt surfaces roughened.
e. Signs of wear on edges or outer surfaces of belt.
Lubrication Points
1. Lubricate the following with Quicksilver or Mercury Precision
2‑4‑C with PTFE.
Tube
Ref No.
Description Where Used Part No.
95
2-4-C with
PTFE
Driveshaft bearing 92-802859A 1
IMPORTANT: It is important not to use a general all‑purpose
grease for this bearing. The lubricant recommended is a
water‑resistant grease of the proper consistency for this
application. If a substitute is used, be sure that it is
water‑resistant.
• Driveshaft bearing
i. Pull vent hose off of the grease fitting.
ii. Pump in grease through the grease fitting, using the
grease gun provided, until excess grease starts to
exit the vent hose.
To Next Page
Loading...
