MAINTENANCE
98 eng
iii. Connect the vent hose onto the grease fitting after
greasing.
a - Grease fitting
b - Vent hose
NOTE: After 30 hours of operation, pump in extra grease to
purge out any moisture. Visually inspecting the purged grease
at this time will give an indication of conditions inside the
bearing housing. A gradual increase in moisture content
indicates seal wear. If the grease begins to turn a dark, dirty
gray color, the driveshaft bearing and seals should be inspected
and replaced if necessary. Some discoloration of the grease is
normal during the break‑in period on a new set of seals.
2. Lubricate the following with Quicksilver or Mercury Precision
Lubricants 2‑4‑C with PTFE.
Tube
Ref No.
Description Where Used Part No.
95
2-4-C with
PTFE
Tilt support lever, swivel
bracket, tilt tube, steering cable
grease fitting
92-802859A 1
• Tilt support lever ‑ Lubricate through fitting.
To Next Page
Loading...
