OUTBOARD INSTALLATION
eng 119
BOATS WITH A "V" BOTTOM HULL
1. Measure the width of the leading edge on the water intake
housing. Make a horizontal line on the transom up from the
"V" bottom the same length as the width of the water intake
housing.
a - Horizontal line
b - Width of the leading edge on the water intake housing
2. Place (center) the outboard on the boat transom. Set the
height of the outboard on the boat transom so that the front
edge of the water intake housing is in line with the horizontal
line made in step 1. Temporarily clamp the outboard to the
transom at this position.
3. Fasten the outboard to the transom at this height. Refer to
Fastening the Outboard.
To Next Page
Loading...
