OUTBOARD INSTALLATION
eng 131
8. Install the access cover with two bolts. Tighten the bolts to
the specified torque.
a - Access cover
Description Nm lb‑in. lb‑ft
Access cover bolt 6 53
SHIFT CABLE INSTALLATION
!
WARNING
If not properly installed, the reverse gate can interfere with
water coming off the rudder, suddenly and unexpectedly
slowing the boat. This can cause serious injury or death from
occupants being thrown within or out of the boat. Adjust the
shift cable to prevent the reverse gate from interfering with
water flow off the rudder.
1. Attach the shift cable to the shift cam with a flat washer and
a self‑locking nylon insert locknut as shown. Tighten the
locknut against the flatwasher, then back‑off the locknut 1/4
turn.
2. Place the remote control handle into full forward position.
To Next Page
Loading...
