EasyManuals Logo

Mercury 40 User Manual

Mercury 40
106 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #69 background imageLoading...
Page #69 background image
OPERATION
61
7. Move throttle grip to start position.
.
27239
8. Models without power trim Position the tilt lock lever to the
lock/run position.
a
b
26802
a - Tilt position b - Lock/run position
!
WARNING
Rapid acceleration can result in serious injury or death from
being thrown within or out of the boat. Decrease engine speed
before shifting into gear.
9. Manual starting models:
a. If engine is cold, push in the primer bulb rapidly 4 to 6 times.
NOTE: For initial start of a new engine or first start after a
prolonged storage, primer lines may have air in them. In this case,
push in the primer bulb several times until fluid can be felt and
then the normal 4 to 6 times.
3076

Table of Contents

Other manuals for Mercury 40

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury 40 and is the answer not in the manual?

Mercury 40 Specifications

General IconGeneral
Horsepower40 hp
Starting SystemElectric
SteeringRemote
Fuel Induction SystemEFI (Electronic Fuel Injection)
Shaft Length20"
Full Throttle RPM Range6000

Related product manuals