Mercury 50 4-Stroke - Page 131

OUTBOARD INSTALLATION
123
6. Secure propeller nut by bending three of the tabs into the
thrust hub grooves.
26945
PROPELLER INSTALLATION - 87.3 MM (3-7/16 IN.)
DIAMETER GEARCASE
!
WARNING
Rotating propellers can cause serious injury or death. Never
operate the boat out of the water with a propeller installed. Before
installing or removing a propeller, place the drive unit in neutral
and engage the lanyard stop switch to prevent the engine from
starting.
1. Coat the propeller shaft with Quicksilver or Mercury Precision
Lubricants Anti‑Corrosion Grease or 2‑4‑C Marine Lubricant
with Teflon.
26902
Tube Ref No. Description Where Used Part No.
94
Anti-Corrosion
Grease
Propeller shaft
92-802867Q
1
95
2-4-C Marine
Lubricant with Teflon
Propeller shaft 92-802859A1