MAINTENANCE
69
REMOVAL
1. Read the preceeding fuel system servicing information and
warning.
2. Pull out the filter assembly from mount. Hold onto the cover to
prevent it from turning and remove the sight bowl. Empty
contents into an approved container.
3. Inspect the filter element, If replacement is necessary, replace
the filter assembly.
a - Cover
b - Filter element
c - O‑ring seal
d - Sight bowl
INSTALLATION
IMPORTANT: Visually inspect for fuel leakage from the filter by
squeezing the primer bulb until firm, forcing fuel into the filter.
1. Push the filter element into the cover.
2. Place the O‑ring seal into its proper position on the sight bowl
and screw the sight bowl hand tight into the cover.
3. Push the filter assembly back into the mount.
Steering Link Rod Fasteners
IMPORTANT: The steering link rod that connects the steering
cable to the engine must be fastened using special washer head
bolt ("e" ‑ Part Number 10‑856680) and self‑locking nylon insert
locknuts ("b" & "d" ‑ Part Number 11‑826709113). These locknuts
must never be replaced with common nuts (non‑locking) as they
will work loose and vibrate off, freeing the link rod to disengage.
To Next Page
Loading...
Need help?
General
